> How do I search the archives for the recent discussions on rotary
> tables - in particular the submission(s) about using a vice in the
> tapered MT center hole?
The archives are at http://www.team.net/archive/shop-talk but I don't recall
any discussion of using a vice on a rotary table. Which probably explains
why I can't find anything in the archive either.
Perhaps you were thinking of HSM ? I believe there was an article this
month on mounting a lathe chuck to a table ...
Randall
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/shop-talk
|