In the planning stages for the new workshop. I really
appreciate all of the past thoughtful comments on this
topic. Being in Ohio, I will need some sort of heat.
Considering radiant floor, but I have a couple of
questions.
1. Is it still possible to epoxy/paint the floor?
2. One bay will have a lift, but potentially not at
the outset. I am currently leaning toward a 4-post
since I envision needing to store a car up there when
not wrenching, but want to leave myself open to a
2-post. I haven't looked yet, are the dimensions of
"the group" of 2-posters close enough that I could
leave a void zone in the floor tubing in the
approximate areas where the posts would be?
3. If I go with the 4-poster, any problems installing
over radiant heat?
4. For another bay I am considering a Kwiklift
(www.kwiklift.com) Has anyone seen one of these in
action?
Thanks,
Ron
Yahoo! - Official partner of 2002 FIFA World Cup
http://fifaworldcup.yahoo.com
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/shop-talk
|