Hi, Inch.
Please remember to limit your acetylene consumption to 1/7 of your
cylinder volume per hour (75 cu.ft. cylinder -> 11 cfh) for safety.
If you exceed this number, you'll start pulling acetone out of the
cylinder along with the acetylene, and the remaining acetylene can go
unstable. Or the acetone will destroy your regulator. Either way,
it's bad bongos.
Rosebuds often draw huge quantities of gas -- the smallest I could
find (heating metal for casting) drew 25 cfh @ 5 psi.
Donald.
> From: jmark.vanscoter@amd.com
> Date: Sun, 2 Jun 2002 00:04:58 -0500
>
>
> Eric Petrevich wrote:
> >
> > 2-Where is a good place to get a long length of Ox/Ace hose? (1/4 dia) I
> > realized that the hose I have is small dia and it will not power my
> > "rosebud" tip. (needed to rebend the skid plate)
>
> I saw it last night in Home Despot. About $25-$30 for the .250
> hose. No need to wait until the welding supply houses are open.
>
> Mark V.S. in Austin, TX
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/shop-talk
|