Bob :
Might help to tell us what wheel cylinders you have (steel, aluminum,
etc.), but in general I wouldn't risk it. Wrap a turn of friction tape
around the pistons and stuff them in the holes. Thread a bolt or spare
bleed valve into the inlet fitting.
Randall
BOB NOGUEIRA wrote:
>
> I'm rebuilding the a brakes on my project car. The wheel cylinders look to
> be in good shape but have a lot of grease etc on the out side. I was going
> to glass bead blast them but got to wondering if I should protect the bore
> and inlet pipe hole first . Will bead blasting the bores screw up the
> cylinder ?
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/shop-talk
|