I'm sorry. I've been looking through all of my old mags on this one and
can't find the article on mounting a vise.
If I every see it, I'll post it.
Sorry folks, I tried.
inch
ken.landaiche@nokia.com
02/14/2001 01:33 PM
To: Epetrevich@relavis.com, shop-talk@autox.team.net
cc:
Subject: RE: Vise location and mounting
Inch,
Please post if you find an article.
Now for a really loaded question: Which vise should I get?
Regards,
Ken
-----Original Message-----
In one of the magazines I get, they say to mount the vice so you can use a
2X4 scrap on the inside jaw and have it even with the edge of the table.
That way, you can put a piece of wood that hangs below the top of the
workbench and just use a 2X4 to make it even with the edge.
Sorry, I'm bad at explaining things. If anyone needs any clarity on it, I
can try to find the article and post the pictures.
Inch
///
/// shop-talk@autox.team.net mailing list
///
|