In a message dated 6/25/00 11:49:07 PM Central Daylight Time,
IrritableIam@aol.com writes:
<< I'm looking for a tool to make a go kart frame for my son, I've seen them
I
just dont know what they are called or where to find one. the tool I am
looking for will cut the radiuses in the pipe so it can be welded properly
if
anyone knows where i CAN FIND ONE PLEASE RESPOND >>
Dale Welch has them... I'll try to dig out his address. It is a jig with a
hole saw attachment and a pipe holder that you clamp on your drill press.
You can probably do the same with an angle vice from Sears, a few bimetal
hole saws and some careful planning if you have a drill press. The device is
neat though, no question about that.
Ron
|