Anyone ever used one of those $40 RSCs that Toolcrib sells to slow down a
bench grinder, polisher or wet grinder instead of a router?
It claims to "reduce speed electronically without reducing torque;
electronic feedback maintains speed by increasing voltage to motor as load
increases. Adjustable speed from 0 rpm to full speed. Full power & torque
at all speeds. Works with routers 3-1/4" HP or less. 120-volt,
15-amp. Does not work with soft-start routers." Has a 3 position switch
(variable, off, full speed).
I'm thinking that it should be fine because how does the darn thing know if
you're using a 1/2 HP bench grinder or a 2 HP router. Start up draw
shouldn't be too high to fry it, I think....
Cheers!
|