On Mon, Jan 10, 2000 at 07:46:07AM -0800, Tim Mullen wrote:
>
> Help.
>
> I'm trying to take the crankshaft bolt out my 93 Honda accord.
>
> It's not really corroded (not rusty...), but I can't get it to come loose.
>
> I've tried a 600 ft.lb impact wrench, a breaker bar with cheater bar (hard to
>hold the flywheel fro turning with the engine in the car - I'm just trying to
>change the timing belts...) and heating the bolt with my propane torch. Any
>suggestions? Try a 3/4 impact wrench? -Where do I rent one? or do I rent
>(can you?) an oxy/acetylene torch to get it really hot?
>
> This one has me stumped...
It's not left-hand threaded is it?
I've done that.
--
Eric Murray www.lne.com/~ericm ericm at the site lne.com PGP keyid:E03F65E5
|