On Mon, May 17, 1999 at 09:55:15AM -0400, cw26@daimlerchrysler.com wrote:
>
> Recently my sun broke the nut along with the end of the crankshaft (that was
>in
> the nut) off of his motorcycle. Any ideas on fixing this short of replacing
>the
> crankshaft?
If the crank is a pressed-together type, you might be able
to get a crank-builder to replace the end that's broken.
That might be cheaper than replacing the crank. You will
still have to split the cases and remove the crank.
Falicon is one crank builder I have dealt with. They're good but
not cheap.
--
Eric Murray N*Able Technologies www.nabletech.com
(email: ericm at the sites lne.com or nabletech.com) PGP keyid:E03F65E5
|