I put locking casters on mine. Works handy as a scaffle. I used cat litter
boxes for drawers. On the two ends without drawers, I used 1/4" plywood. I
drilled holes in the plywood so I could put in peg board hangers and hooks.
I have hammers, grinder, clamps, a drill, pipe cutter, etc hanging from the
hangers and hooks. The top is made from 2x8s. The top hangs over in each
direction to make it easy to clamp to. On one drawer side, I have two nails
on which I hang brushes. I has a bottom which acts as a shelf. I have a
vise in one corner. I find it very useful.
-----Original Message-----
From: Ken Landaiche <ken.landaiche@dlcc.com>
To: Shop Talk <shop-talk@triumph.cs.utah.edu>
Date: Monday, January 11, 1999 12:13 PM
Subject: Workbench plans
>
>It seems to be time for the annual workbench discussion, so I'll start
>it off. I know from previous threads that bench heights ought to be
>about elbow level for general work, with some sections at lower heights
>suitable for rebuilding the engines of our favorite cars. Some have
>suggested castering to make maneuvering easier, though I wonder how
>pounding on a vice would work on a castered workbench. And the
>electrical outlets should have been installed at a height that clears
>the benches.
>
>Now that I am approaching the need to build my benches, I wonder if
>anyone has or knows of plans for benches on say a two or four foot
>module with provisions for storage below in either drawers or doors. I
>am leaning toward tool storage in bearing-slide tool chests located on
>some bench surfaces, with more storage shelves above those.
>
>If by some chance no such plans exist, I could draw up a set, using the
>list's input, and upload them to the plans area.
>
>Any thoughts?
>
>Ken Landaiche
|