Probably another FAQ for some of you, but I'm ready to #@!$$&# at one of
the u-joints on my right rear axle assembly (TR6). I think I know all
of the "common" tricks, but cannot get one of the bearing cups to come
out. It will move to a point where it is flush with the outer yoke
face, but will come no farther. I've already removed the rubber seals,
soaked in liquid wrench, and moved up to the small sledge, but don't
want to destroy the yoke. Suggestions, anyone??
Martin Libhart
1972 TR6 (driver)
1970 Spitfire (under the knife)
|