'50, 3100 Chevy PU.?? .
Gas gauge was working fine until about three days age.
??Noticed as I started the truck, gauge was not working. Tapped the
gauge cluster and the gas gauge started working.
Then yesterday, same thing, only this time, after tapping the cluster.
the gauge never started working.
It's stuck in the empty position. I've removed the sending unit wire,
with ignition on and there's no movement.
?????? Also touched it to ground same result.
Checked grounding at the sending unit and all is good.
I do not get any power indication at the sending unit
Another other suggestions to check??? Hate to think it's the gauge,
removing the cluster is a cluster . . .
If the gauge is bad, has anyone connected an after market (externally
mounted) gas gauge?
How'd that work out ?
Thanks
--
This e-mail messages is for the sole use of the intended recipient(s)
and may contain confidential and privileged information.
Any unauthorized review, use, disclosure or distribution is prohibited.
If you are not the intended recipient, please contact the sender
by e-mail and destroy all copies of the original message.
---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus
_______________________________________________
Oletrucks@autox.team.net
Archive: http://www.team.net/pipermail/oletrucks
|