Hey all,
I'm getting ready to install a TCI custom IFS in a 51 Chevy 3100. It says
to mark the front axle center-line and go from there. What actually is the
front axle center-line? Is it straight done from the frame to the center of the
axle as it passes under or is it the actual center at top of the kingpin
measured across? I sure want to get it right.
I've found directions for 47-54 with the two piece ifs (with spring towers)
that says to measure 18 1/8" back from the center of the forward spring perch
hole, but that does not look right to me. Any help would be appreciated.
On another note, I have me four link and rear end all painted and ready to
put in. I just need to paint the pack of the frame and get some buddies over
here to get the cab off to do the rest. I sure miss the son and his football
buddies. It was amazing the help you could get for a few sodas and burgers.
Grocery bill is alot less now though.
Thanks in advance!
Steve Stuckmeyer
51 3100
St Peters, MO
---------------------------------
How low will we go? Check out Yahoo! Messengers low PC-to-Phone call rates.
|