The rubber seal with the wire through the middle of it fits into the
headlight rim at the edge were it seals around the retainer ring on the
headlight bulb. The seals may be a little on the long side and will
probably have to be trimmed a little in length to get a perfect fit. The
wire does not need to be trimmed as the excess will fit up into the opening
on the opposite side. You will also need some wire spring clip retainers to
install and hold the seal in place. If you haven't got them you will need
to order them as the seals will not stay in place without them. They are,
from my own experience , quite easy to install.
Take your time, think about what you are doing and good luck!!!
Mac
52 Chev 1300
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|