As Alan suggested using the lowering blocks, that works fine on the AD but
the TF trucks has the rear end housing underneath the leaf spring pack
where the AD housing is on top of the spring. What year is your truck and
if TF there are spring hangers that will get ya a bit of drop. I personally
removed a couple of springs from the pack to get a bit of drop. I used the
monos leafs on the front end of my truck. Although you can't remove leaves
on the rear if you're planning on hauling heavy items as the load capacity
is greatly reduced. --wayne
At 06:06 PM 2/11/2005 -0500, BDub2986@aol.com wrote:
>Has anyone tried lowering their rear end by using one of those single
>steel leaf springs? I was curious to see if it would work or if a single
>leaf from a 3/4 ton or 1 ton truck would work.
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|