Hello, All.
I have just about completed installing a Mustang II front suspension in my
1955 AD. I'm using stock Mustang spindles and upper and lower control arms
from the boneyard. I notice that when I install the modified Granada 11 inch
rotors, I only have a few thousands of clearance between the inside of the
rotor and the lower control arm. I asked the dkit manufacturer and they said
to grind away a litttle of the outer edge of the control arm. No problem
there since there is plenty of material, but I'm wondering how much clearance
I should have. A sixteenth of an inch? An eighth?
All help is appreciated.
Harry
1955 Chevy AD
Reno, NV
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|