I think I asked this before and didn't get any suggestions, but I'll try once
more.
My V8 is currently on a traditional engine stand, but I want to move it to a
"stand"
that will let me set up, install, bolt up engine clutch/flywheel, and
transmission.
Eastwood sells a stand where the engine rests on the lip of the oil pan, but I
don't
want to booger up my nice new oil pan and engine paint.
And I would rather have a setup that resembles the original format if possible
and
keeping it low to make it easy and safe to move around. I don't really want to
cut off
the front of a frame and put wheels on it...seems like a waste when good old
truck
hardware is getting harder to find, but...
Any suggestions?
I'm actually thinking about building something in wood 4 by 4's.
Mark Noakes
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|