Depending on how bad you want to keep that 6 lug rear end (and how many $$$ you
are willing to spend) you should be able to figure out who actually makes the
rotors and either get them to drill a 6 lug model for you or sell you blank
rotors and you could find a machine shop to drill them for you.
-----Original Message-----
From: owner-oletrucks@autox.team.net
[mailto:owner-oletrucks@autox.team.net]On Behalf Of Spencer
Sent: Thursday, May 20, 2004 8:37 PM
To: oletrucks@autox.team.net
Subject: [oletrucks] Rotors for MII IFS
Hello, All. I've just about got my Chassis Engineering Mustang II front end
kit in place, POR15ed, and ready for rotors.
Many vendors offer 11" rotors with a Chevy five lug pattern. I'm curious if
these are a stock rotor from a GM car with a different bearing set that fits
them to the Mustang spindles. Anyone know? I've got access to some nearly
new rotors from a '78 Monte Carlo.
Second, and this one is a long shot from what I can tell, does any vendor
offer a six lug rotor for the Mustang II IFS? I'd like to keep my stock six
lug rear end.
Thanks.
Harry Spencer
1955 1st Series Chevy finally making progress.
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|