> Date: Mon, 26 Apr 2004 05:59:01 -0700
> From: "Spencer" <wits_end@worldnet.att.net>
> Subject: [oletrucks] Sheet metal gauge?
>
> Hi, All.
>
> I need to buy sheet metal for somesmall patches on my cab floor. What
> thickness/gauge should I buy?
The floor and other inner panels will be about 18 gage,
you'll want cold rolled so it'll weld easily.
> Also, I'm planning to tack weld some reinforcement sheet metal to the
> underneath side of the floor for seat belt attachment points. I'm thinking
> a six inch by six inch square ought to do the trick. Any thoughts?
That would be plenty big, if you use thick enough metal,
such as 16 gage (1/16") up to 11 gage (1/8"). The companies
that sell aftermarket seat belts usually include a 2.5"
diameter washer that's about 16 gage, they conside that
sufficient reinforcement.
--
Jim
Visit the Selectric Typewriter Museum at it's new home!
http://www.selectric.org
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|