[oletrucks] off topic and unusual efi questions

[mark@noakes.com]

Sorry for the off-topic post, but I figure that this was where I could get 
appropriate
input...

1--What are fuel injector nozzles typically made of?  Stainless?

2--Are there any really small/low flow injectors out there?

I have an application, where, believe it or not, I need to control down to 10
milli-liters/minute.  Yes, I know I could go with a real low duty cycle, but I 
would
like to keep the flow as constant and even as possible.

Thanks for any assistance,

Mark Noakes

oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959