oletrucks
[Top] [All Lists]

Re: [oletrucks] Storage moisture removal

To: bmdumkee@auroranet.nt.ca, oletrucks@autox.team.net
Subject: Re: [oletrucks] Storage moisture removal
From: Cadamsarch@aol.com
Date: Fri, 15 Aug 2003 15:06:05 EDT
Hello Blaine,

One thing Uncle Sam taught me, in exchange for some Navy time, is that terms 
like "watertight," "weatherproof," and "airtight" are figments of some 
designer's imagination. It's like me wishfully thinking my Stovebolt 216 
doesn't drip 
any oil. 

A few gray hairs as an architect, since then, have me asking, when I look at 
a brick wall, or anything else with a seam or a joint, is "How will the water 
that gets in find it's way out?" 

If I were putting my truck in a shipping container, I'd plan on water sharing 
the space. 

I'd do what you suggest: get the thing up off the ground. When I walk 
outdoors my feet get wetter then my hips, whether the wet comes from dew, rain, 
or 
snow. Off the ground a little is good. Off the ground a lot is better. 

Then I'd do something to keep some rain and snow away. I'd build a simple 
gable roof of used corrugated galvanized steel or whatever comes cheap. I'd 
spend 
a few bucks to add a lapped layer of roofing felt under it. I'd make it so 
the eaves overhang the container enough that wind driven rain mostly blows 
clear. 

Then I'd vent the container. I'd figure the "attic" under the roof has lots 
of warm, dry air. I'd install a "pretty much watertight" roof fitting on the 
container roof toward the north end--similar to a plumbing waste stack vent. 
I'd 
probably duct it to the container floor. This would typically be the supply. 
At the south wall--that's probably where I'd have the door--I'd put in a 
through-wall vent high in the door. This would typically be the exhaust, if 
your 
big winds are from the northwest through northeast like they usually are in 
Minnesota. (We figured this out when we got so busy landing lunker walleyes 
that 
we didn't notice the storm until it washed us onto the south shore. This 
technique doesn't work so well when ice fishing, though.) I'd invest in about 2 
feet 
of a downward pointing duct on each of these openings, so any wind driven 
snow or rain had to fight gravity for a bit. Gravity means nothing to wind, so 
there is some wishful thinking going on here, but the water that comes in will 
go out with the next dry wind. If I still had energy, I'd bug proof the 
openings because I like honey but not hornets.

Then I'd have a cold brew and try not to think about how many projects on my 
AD I could have finished if I hadn't spent so much time making my container 
"pretty much weatherproof."

Thanks for the chance to think about snow and wind and share my humble 
opinion.

Culver Adams
1931 Chevy coupe
1951 Chevy AD
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959

<Prev in Thread] Current Thread [Next in Thread>