Thanks to everyone who resonded to my turn signal question. I'm still pretty
new at this, and even newer to electric, so let me throw a few details out for
you, and ask for even more advice
:-)
First off, my truck was converted to 12V sometime before I got it. Quite
primitively as well, with an open fuse block screwed to the firewall.
Everything works fine, it's just a bit ugly.
Currently I have working rear tail/brake light, single bulb. I don't have
front parking lights (yet)
As I said the other day, I have a four-wire turn signal switch, but will
likely buy the 7-wire one (thanks for the diagram Steve) I don't have a
flasher, and really aren't even sure how I would wire one into the truck.
Short of installing a new harness, would it be feasible to clean this up, and
still add turn signals? Would grabbing a fuse box off another vehicle be
worthwile, or even do-able? And where/how would I add the flasher in, and what
kind should I get? Are 12V flashers all the same, or should I get aspecific one
from a specific vehicle?
Thanks,
-Larry
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|