Santa brought me a set of four clutch head screwdrivers, made by
Channellock. Good solid ones too.
Ed in Mich
'57 3100
----- Original Message -----
From: "Doug Wathor" <wathor@comcast.net>
To: <oletrucks@autox.team.net>
Sent: Saturday, August 09, 2003 4:15 PM
Subject: [oletrucks] Clutch head bits
> We had a post several weeks ago about these clutch head screws and bolts.
At
> the time I thought I was all set, since I had used them once before on a
> 50's era trailer. However, when trying to disassemble the bed on my 56, I
> realized I didn't have the right size, 5/16 I think. I went to my local
> hardware store and they only had the bits up to 3/16, which I already
have.
> My FLAPS did have any at all.
>
> Coming back home and looking on line, I can find the screwdrivers up to
> 5/16, but not just the bits. Does anyone know if 5/16 are made in just the
> bit form and where to get them? Actually a set of bits up to 5/16 would be
> nice. Thanks.
>
> Doug
> Livermore, CA
> 63 Vette
> 56 TF
> oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|