The mystery hole is located approximately over where the front U-joint would
be, about 18" forward from the hole the gas line feeds through. I'm
wondering if I can weld it shut. Harry
----- Original Message -----
From: Dane Bruce <nochay@earthlink.net>
To: 'Spencer' <wits_end@worldnet.att.net>
Cc: <oletrucks@autox.team.net>
Sent: Thursday, July 17, 2003 6:36 PM
Subject: RE: [oletrucks] Bottom of cab
> Hey Harry,
>
> 2. there is a hole in the center of the cab floor directly under where
> the
> seat would go. It's about an inch in diameter with a good sized notch
> on
> either side. Anyone know what it is for?
>
> Closest I can think of would be for the master cylinder service hole. Is
> it about that size? My mom's truck has one similar to what you are
> describing.
>
> Dane
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|