If the rear end is stock configuration (axle UNDER springs) lowering blocks
become raising blocks. Not helpful in your case.
-----Original Message-----
From: Ryan Sain [mailto:rsain@gte.net]
Sent: Thursday, July 17, 2003 2:05 PM
To: oletrucks
Subject: [oletrucks] Stance?
I have a question!
The stance of our existing frame is a little too extreme for me. We have a
4.5" drop from rear to front.
I expect the rear to drop a little with the bed and bumper added on, but not
much. I expect the front to drop some as well when the motor and tranny and
body are assembled.
However, my gut tells me that this is still too much of a rake to look good.
What rake do you all have on your rigs? What do you suggest as far as total
drop from rear to front?
My current solution is to assemble the truck, then add lowering blocks in
the rear to get the rake I want. Would anyone do something different here?
- Ryan
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|