Rob,
Basically the horn circuit will take a relay. The horn button supplies
the ground to close the set of points inside the relay. When the
points close current flows to the horn to make it sound.
If you would like, I can draw you up the wiring schematic for wiring in
a 30 Amp Bosch Relay.
Joe
----- Original Message -----
From: "Parkinson, Rob" <Rob_Parkinson@jdedwards.com>
Date: Sunday, July 6, 2003 4:05 pm
Subject: RE: [oletrucks] Rob's horn button.
> Thanks Gary and everybody - I identified the problem.
> I do have one more final (maybe) question -
> The replacement 12v horn I have grounds to the car frame/body
> wherever it's mounted. There is one connection on the horn, which
> is positive. In looking at the wiring diagram, I notice that the
> older style horn had two connections (ground and positive.) The
> ground went to the relay, then the horn button and completed the
> circuit when the horn button was pressed.
> Since the modern horn is already grounded, how will I wire it?
> Thanks for any and all help - remember, I'm a rookie, so need this
> type of stuff spelled out like in a childrens book.
> Rob
>
> -----Original Message-----
> From: Gary Perry [glperry@fwi.com]
> Sent: Wed 7/2/2003 8:21 PM
> To: oletrucks@autox.team.net
> Cc:
> Subject: [oletrucks] Rob's horn button.
>
>
>
> Rob, been awhile since I've done one, just trying to go by
> remembering what I
> had. Leave the spring under the str wheel. Mount steer wheel,
> then should be a
> hole in it that's smooth, not the two threaded ones, they are
for
> puller is
> all. Insert the graphite end of spring/wire/graphite item into
> hole. This goes
> down and touches that slip ring all the time you turn or
> otherwise. Now
> somewhere in here is a flat metal plate that will float maybe
or
> maybe the
> center goes under the wheel nut to hold it in??? Somewhere a
> spring goes in
> center and pushes back on the horn button which is forced over
> the first flat
> metal part to hold it up off the middle stud or shaft??? When
> you press the
> button, it touches that shaft and is grounded ringing horn. The
> wire going out
> to relay through column is attached to that brass ring at top
of
> column. Now, I hope most of this is right! Kinda hard
> w/out parts in front of me.
> Also, I can't send to your address, it came back, so went to
this
> site.
> G. L. Grumpy's
> Old Iron Ranch
> Huntington, IN 46750
> AD trucks and MM tractors
> oletrucks is devoted to Chevy and GM trucks built between 1941
> and 1959
> oletrucks is devoted to Chevy and GM trucks built between 1941 and
> 1959
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|