Re: my missing speedo driven gear....
Ok, maybe you all tried to tell me this and I totally missed it...(no i'm
not blonde)...but I just got off the phone with someone at the Speedometer
Shop...and he said, Try any gear, the number of teeth is in relation to the
rear axle ratio...not 3 spd or 4 spd, etc... So, what I should do, is just
put any gear on there, and then do some calculations that he provided, and
then he can tell me how many teeth I should actually have...He cannot figure
it out without some numbers...unless i want to take the transmission
apart...
So, that is what I'm going to do. Thanks to all your help, and the next
update should be.....It works!
Side Note: Bill at www.speedometershop.com was extremely pleasant and very
helpful...(as are all of you!)
Karen Duff
53 3100
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|