Curve goes down, Mark (bumper is lower than frame rail ends)
Larry Kephart
1955 1st 3100 Chevy (BillyBob)
1991 Jeep Wrangler (Renegade)
Boca Raton, Florida
e-mail: webmaster@laroke.com
http://www.laroke.com/larryk4674/1998/billybob.htm
-----Original Message-----
From: owner-oletrucks@autox.team.net
[mailto:owner-oletrucks@autox.team.net]On Behalf Of Mark Self
Sent: Sunday, June 22, 2003 10:23 AM
To: Oletrucks Mailing List
Subject: [oletrucks] AD rear bumper bracket question
My truck (55 1st, 3100 = ton) came without a rear bumper. I got a set
of used brackets from Jim Carter. My factory assembly guide shows that
they bolt to the outside of the frame channel. Looking from the side of
the bracket, there is about a one inch offset curve. This will raise or
lower the bumper height. My question: does this curve go up or down?
Im guessing down.
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|