Smokey,
I searched high and low all over the e-virtual and physical place and
couldn't find one either. The one I had on my '51 3600 was frayed somewhat
around the edges, so I just cleaned it up, trimmed the mess a little and
re-installed it. I figured that since it doesn't handle a rotating or
moving load at all, it should be fine.
As I was considering all that, I toyed with the idea of making one out of a
block of rubber, but gave it up as being too complex for my limited skills!
If you do find one to buy out there, buy 2 and we'll make a deal!!!
R.D. Hulst
A Canuck in Kentucky with a '51 3600 in a ka-gillion pieces
Date: Thu, 19 Jun 2003 11:03:41 -0500
From: "Charles Culver" <clca@houston.rr.com>
Subject: [oletrucks] RE: oletrucks-digest V2 #1954
I need to replace the rubber bushing for the closed drive shaft mounting
bracket on my 1950 3600. Cant' seem to locate one; Can anyone help me out?
Thanks!
Smokey Culver
League City, Texas
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
_________________________________________________________________
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|