Hi
Allways make 2 checks when installing a clutch, lay the disk on the flywheel
, it will usually only lay flat only one way this is the way to install it.
Next slide disk on spline of trans and check for proper fit. This check is
because several car co's used the same dia disk with a different spline hub,
this can get very frustrating when trying to slide a trans into a hub that
won't fit.
Lee
----- Original Message -----
From: <OlHic@aol.com>
To: <oletrucks@autox.team.net>
Sent: Monday, June 02, 2003 6:25 PM
Subject: [oletrucks] clutch question
> installing a 235 in my 46 3/4 ton and am in the process of installing the
> clutch. this is my first clutch installation and it seems rather simple,
but i do
> have one question. On the clutch disc, should the protusion that goes over
> the splines be toward the front or toward the rear. the manual isnt real
clear
> on this and i want to get it right the first time. Thanks for any help
> Phil Faircloth
> 46 3/4 ton
> 51 3800
> 51 burb
> oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|