Wayne
I would be interested in your feedback on the Volare swap. I am an
experienced fabricator and the installation looks easy enough. I'm concerned
about the look & ride. The cost is appealing. I watch the replies to Carl
very close, most of them were on fabricated units. I am about to fork over
the cash for a MII. Feedback?
Kurt Ohlgren
58 3100
59 3800
>From: wayne osborne <wayne@chevytrucks.org>
>Reply-To: wayne osborne <wayne@chevytrucks.org>
>To: "william moldenhauer" <wmh678@worldnet.att.net>, "OleTrucks"
><oletrucks@autox.team.net>
>Subject: Re: [oletrucks] new project
>Date: Wed, 05 Feb 2003 08:27:36 -0500
>
>William,
> That sounds like a wonderful idea.... I keep getting some articles
>from
>the list members to go on my site and have been asked by outside emails
>about clipping a truck, and realized that I don't have any info up for
>that. I have the Volare clip install, but not much else. A CD of the
>process would be just absolutely great.
> Thanks to all who forwarded info regarding a clip job, want to go
>through some and get some sort of info up on this. Carl Ham recently
>composed and submitted all the replies when he poses the question to the
>list on IFS units, he did this for his records but the write was great for
>those toying with the idea of the drop in type crossmembers.. Its
>under the tech section on http://www.chevytrucks.org
>
>Thanks again.. --wayne
>
_________________________________________________________________
Add photos to your e-mail with MSN 8. Get 2 months FREE*.
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|