I thought you didn't have to top coat it? I knew it would fade, but I
thought it retained the rest of its properties...
>From: "Jeffrey Cerniglia" <jcerniglia@msn.com>
>To: "kmm 1024" <kmm1024@hotmail.com>
>Subject: Re: [oletrucks] por15 and bubbles
>Date: Tue, 13 Aug 2002 20:43:19 -0400
>
>It could be because of oil on the surface, try a spot and clean it good
>first with enamel reducer then paint it, see of you get the same results.
>Make sure you top coat POR15
>after or it will degrade and flake in sunlight. The best way is to top coat
>when it is still
>tacky, saves time scuffing and comes out nice.
>
>Jeff Cerniglia
>1959 GMC Fleetside
>Bristol, CT
>
>----- Original Message -----
>From: kmm 1024
>Sent: Tuesday, August 13, 2002 4:05 PM
>To: old-chevy-truck@yahoogroups.com; oletrucks@autox.team.net
>Subject: [oletrucks] por15 and bubbles
>
>I'm painting my frame with POR15 by brushing it on, and when I first brush
>it on there are a lot of bubbles. About half of them pop, but after a
>minute the paint has setup enough where the rest don't. It gives quite a
>texture. What am I doing wrong? The surface is clean (and sandblasted).
>
>_________________________________________________________________
>Join the worlds largest e-mail service with MSN Hotmail.
>http://www.hotmail.com
>oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
_________________________________________________________________
Join the worlds largest e-mail service with MSN Hotmail.
http://www.hotmail.com
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|