Dave,
A friend of mine taped his of below the ridges and had them (the ridges) sprayed
with the new spray on bed-liner (Rhino bed-liner).
Joel
51 Panel
Arlington, Texas
-----Original Message-----
From: CraggD@aol.com [SMTP:CraggD@aol.com]
Sent: Saturday, June 29, 2002 4:33 PM
To: oletrucks@autox.team.net; old-chevy-truck@yahoogroups.com
Subject: [oletrucks] Runningboard restoration
I pulled my running boards to strip and refinish. They cleaned up great and
looked super when I put them back on. But... now six months later the surface
is pretty scratched up. What have you done to keep the surface unmarred?
Powder coating? Any rubber surface solutions? I have looked at stepping
plates (a potential partial solution, doesn't protect the rear step area used
for reaching in the bed) but most are Chevy stamped and I have a GMC. Any
ideas would be appreciated. Thanks, Dave
'49 GMC 1/2 ton
"Nellie"
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|