I pulled my running boards to strip and refinish. They cleaned up great and
looked super when I put them back on. But... now six months later the surface
is pretty scratched up. What have you done to keep the surface unmarred?
Powder coating? Any rubber surface solutions? I have looked at stepping
plates (a potential partial solution, doesn't protect the rear step area used
for reaching in the bed) but most are Chevy stamped and I have a GMC. Any
ideas would be appreciated. Thanks, Dave
'49 GMC 1/2 ton
"Nellie"
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|