I worked on my brakes yesterday and could not get them to hold pressure. I
would pump the brake and get good peddle, then I would let off for 2 or 3
seconds and it would go right to the floor. We bled all the lines and they
seem fine. My question is this; when I remove the fill cap on the master
cylinder and push the peddle down, fluid comes shooting up from the cylinder
into the reservoir. Is this normal or do I have a bad master cylinder? Did
I not bleed it right or am I missing a trick that only ole' time truckers
know? Any help would be great!
Thanks,
Lon
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|