I have a small on/off switch which will fit in the same location. The visible
part of
the switch is very similar.
If you are intent on "fixin" the old one, contact me with an address to mail you
this thingamabob for you to play with.
Ray
Doug Pewterbaugh wrote:
> Before you spend a lot of time looking; I've only seen entire dome lights
> for sale as used (mostly auction). Just get a piece of printed circuit
> board yourself & makeshift. I don't think you'll find much else. That's
> pretty small stuff to see from the vendors, even with the increase of
> supplies I've seen in the market over the past 20 yrs. Then again, someone
> may hand you one or point you to a vendor & maybe I'm just a pessimist!
>
> Regards,
> Doug Pewterbaugh
> dpewter@msn.com
> Denton, TX
> 49 3104 216 5-window
>
> ----- Original Message -----
> From: <JL31139@aol.com>
> To: <oletrucks@autox.team.net>
> Sent: Wednesday, April 03, 2002 10:32 PM
> Subject: [oletrucks] Dome light
>
> > While trying to replace the pigtail wire in my interior dome light I broke
> > the
> > Off / On switch. . . the fiber board that has the two wiring connections
> just
> > crumbled. Does anyone know where you can get this Off / On switch.
> > The dome light is original and I would really like to stay with it and
> just
> > replace the
> > fiber board and switch if possible. THANKS
> > Thanks - JL / Birmingham 1953 3100
> > oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
> oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|