Sorry Steve, I don't have a clue! I have a '55 and Brothers makes a kit
to make them one piece windows .. I know some of the earlier trucks had
one piece and some had vent windows .. I don't know if you can take the
windows and hardware out and put them in another door, or if you just
have to swap doors completely!
Bill
> -----Original Message-----
> From: Nelson, Steve [mailto:snelson@barronind.com]
> Sent: Thursday, April 04, 2002 8:52 AM
> To: Bill Broadway; 'OLE-CHEVY-TRUCKS'
> Subject: RE: [oletrucks] Bolt in power window kit
>
> I have to replace the side glass in my 54 AD and the vent window pivot
> pins
> are pretty soft. I wondered how difficult it is to convert to one
piece
> windows. This makes it sound like I can use the glass from an earlier
> model
> and simplify my work. Is that true? Will that work with the standard
> regulator, as well.
>
> Steve
>
> -----Original Message-----
> From: owner-oletrucks@autox.team.net
> [mailto:owner-oletrucks@autox.team.net] On Behalf Of Bill Broadway
> Sent: Wednesday, April 03, 2002 4:12 PM
> To: 'OLE-CHEVY-TRUCKS'
> Subject: RE: [oletrucks] Bolt in power window kit
>
> > Has anyone tried the bolt in power window kit from
> A1-Electric? These
> kits
> > are for 47-54 ADs and use the factory one piece
windows
> and are
> designed
> > to bolt in where the factory manual window regulators
were
> installed.
>
> While I don't have an AD truck, I did go look .. and
what
> interested me
> was that A1 sells a power window kit that works with the
> brothers 1
> piece windows for 55-59 trucks. At brothers, one piece
> windows with
> power is over $700 ... but you can get one piece manual
> windows for $329
> .. add in the kit from A1 and you're only at about $570
..
> anyone done
> just this? The only problem I see is that if you run
into a
> snag,
> Brothers will be less likely to help you out.
>
> Bill
> oletrucks is devoted to Chevy and GM trucks built
between
> 1941 and 1959
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|