I saw on Hot Rod TV (I think) a demonstration of how to make a fiberglass
copy of a trim part. The example they used was the headlight bezel from a
car. The process seemed simple enough, and the result was good.
Has anybody tried this before? I'd like to do this for the '58-'59 GMC turn
signal assembly, but I don't have an original to use as a pattern. Anybody
wanna try it? I'd pay for a set! I wouldn't care if they weren't
translucent like the originals, just nice and paintable. Somebody want to
loan a set to make the mold (harmless to original piece)? I'm sure there
would be more interest. . . just try to find a set.
Thanks
GOP
'59 GMC 100 flatbed
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|