Sounds like your 180 out. Loosen the distributor hold down, take the cap
off the distributor, take note of where the rotor is pointing and then
wiggle the distributor up until the distributor gear clears the cam gear and
rotate the rotor 180 degrees. Tighten everything down and it should make
that Vrooooommmmmmm sound.
Now this is a Chevy 350 correct and not an Oldsmobile 350 Right?
-----Original Message-----
From: laurie <lauriecorbett@ns.sympatico.ca>
To: oletrucks@autox.team.net <oletrucks@autox.team.net>
Date: Thursday, December 20, 2001 3:04 PM
Subject: [oletrucks] engine help
>ok i tried everythig to get my 350 working...i put #1 cylinder up tdc took
off
>valve cover to make sure the valves were closed droped the distributor in
it
>was pointing to #1 cylinder...i wired her up and nothing.........all i get
is
>a pop pop pop like its burining the gas but no vrooommmm....i got lots of
>spark/new plugs wires
>i dunno what to do ...
>help me please....
>mike
>oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|