If you're speaking of the one that the large filler neck goes through, you
need to remove the filler neck, then install the grommet. Apply Wd40 on
the grommet and slide the filler neck up from the inside., then back down
to attche to the other two pieces of tubing (vent and fill tube).
Mike
> [Original Message]
> From: <McGillis@aol.com>
> To: <oletrucks@autox.team.net>
> Date: 10/14/01 6:26:54 AM
> Subject: [oletrucks] TF Gas Neck Grommet Install
>
> Has anyone installed a new Gas Neck Grommet in a TF truck? I put a new
tank
> in my 1955 Cameo and had a terrible time with the grommet between the
fill
> pipe and body, eventually ruining it. I never did get it right and am
> driving without. I bought a new grommet and hope a list member can tell
me
> the right way to install it.
>
> Thanks for any help.
>
> Dennis McGillis
> Vintage Chevrolet Club of America
> Orange County (CA) Region
> 949-551-4821 phone
> 949-551-1162 fax
> oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
--- Mike
--- passnb4u@earthlink.net
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|