Use the special screwdriver to tighten the hidden screw holding the terminal
stud tight. Make special screwdriver from a slotted screwdriver that you have
cut a large notch out of the tip.
there must be pictures of this in shop manual, as I'm doing a poor job of
describing it. Go gently as the bakelite likes to break at that stud.
Bob Adler
> The screw in the bottom of the distributor that the coil wire connects to
> on the outside and the points connect to on the inside seemed loose and
> required an extra washer on the inside.
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|