[In the prosses of removeng the axels] There is that solid cylinder pin that
holds the nessasary tension on the U clips and the axeles. The smaller
bolt/pin that anchors the solid cylinder in place broke off at the end of the
threads[about half way]. It must have been well on the way before I got to
it,because it came the first half with very little resistance.and then broke
while working it out with fingers.
QUESTION STARTS HERE;
Does this break indicate a vibration or tention/pintch or any other
concievable problem I should worry about? Perhaps the last guy just over did
it. Thanks.
e
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|