I know of one for the 40-46 in a yard that I should be at in the next few
days. They had 2 and I got the best one (lower part only) but the other is
not that bad. I am only using the bottom and it was a full set (top and
bottom). Are you looking for just the springs or do you want more than the
seats?
I am using what I got to replacement the bench that came in my 46. It is a
split seat that is pushed together about 40 percent on driver side and 60
percent on passenger. It seem thicker that the original. But it is the
same width. Do you want me to take a photo of it and e-mail it to you or
put it out on my web site? (like the fender mounting screws)
Are you going to Manchester VT this Saturday?
I did appreciate you comments about the compressor and understand where you
are coming from. I think I am going with the smaller one - this one both my
wife and I can live with. I know for blasting it will cause me to wait
however due to my nature this could be a good thing. Much better that
blasting ahead and then fixing the job because I did not think through the
best way to get the job done. Going slow is not one of my better
attributes.
Let me know what you want to do.
NHJim
46 Chevy 3104
-----Original Message-----
From: Advdesign1@aol.com [mailto:Advdesign1@aol.com]
Sent: Tuesday, June 05, 2001 9:25 PM
To: oletrucks@autox.team.net; old-chevy-truck@yahoogroups.com
Subject: [old-chevy-truck] Need used seats 37 and 46
Does anyone have decent used seat springs and frames for a 37PU? this is
the
one with split cushion, used from late 36 to early 38. Around New York the
springs get totally rotted out, so they collapse in.
I need the same for 1940-46 pu. Both are for stock restoration. They must
be recoverable.
Got spares or leads? I already called everyone advertising in latest
Hemmings
Bob ADler
Ole Chevy and GMC trucks rule!
Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|