Well in another famous what can I do in an hour - I decided to sand and
paint the crank out windshield in the 46. I did not mask off or tape - just
fired up the sander and went after the rusty medal. Well not thinking the
spinning pad touched the glass (in 2 spots) and now the glass has a few
scratches in it. I was using 150 grit paper. Before I go to far, it was
masked primed then painted and came out great. On the down side the paint
faded from last year, so maybe I need to repaint the whole thing (another 5
cans or Rustoloum). This is all just a temp cover until I can do it
correctly (est. 2003).
Back to the question. Is there a rubbing compound or something I can use to
get the scratches out of the glass? Once again I am learning on the job.
Thanks,
NHJim
46 Chevy 3104
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|