I guess I'm looking for a Ford 9" rearend with the smaller bolt spacing (4"
something, not 5"), with the right width (about 60")...and these only came
in rare mustangs, cougars, etc. with big blocks (or it'd have 8")...this is
going to be tuff to find (or expensive).
-----Original Message-----
From: owner-oletrucks@autox.team.net
[mailto:owner-oletrucks@autox.team.net]On Behalf Of Al&Judy
Sent: Monday, May 07, 2001 10:52 AM
To: oletrucks@autox.team.net
Subject: Re: [oletrucks] Rearend sizing
Oletruckers, for all the info you could ever want on Nova/Ventura etc. rear
ends, check out
www.geocities.com/MotorCity/Speedway/6432/ , widths, ratios, codes, it is
all there under axle codes.
Al
49/54 Rod project
----- Original Message -----
From: <Pastorjon994@cs.com>
To: <jacobh@ida.net>; <oletrucks@autox.team.net>
Sent: Monday, May 07, 2001 12:12 PM
Subject: Re: [oletrucks] Rearend sizing
> <So, if you are looking for a replacement that will not need any changes,
> check out the Ventura.>
>
> Say Jack, do you remember what the ratio is on the 74 Ventura?
>
> Jon Callahan
> '50 3100
> Champaign/Urbana, IL
> oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|