I don't have the tank installed yet. I did set it in place, standing on
some jackstands, and it couldn't be a better fit. The only thing that I
didn't like was the filler neck would have to be out the pass side. Unless
you could just weld a cap on the old neck and cut a new one. Is that
possible? Thanks for the suport on my truck and my mission. I hope you see
some finished photos in a couple years too!!!! :) Anyway, to Old GMC
Pickup, I am using the original frame but it has been boxed and has all new
crossmembers so I don't know if they are in stock locations or not.
Jake Heaton
1953 GMC Panel truck (Rod Project)
Preston, Idaho
www.brigham.net/~jacobh/barndoors/index.htm
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|