Don't take my word on it (there are much more knowledable people here than
me that I'm sure will answer this) .. but I would think you'd need to put
some masking tape on the area that is to be drilled. When ever I've seen
anyone drilling I've always seen them drilling trough the tape.
Bill
> The PO of my 1950 3100 has filled the four "Chevrolet" emblem holes in
> the front of the hood and finished/painted over them. I've purchased a
> new emblem and need to re-drill the holes out. This means drilling from
> inside the hood out through the finished paint. Is there any danger or
> chance of chipping or cracking the paint as I drill through it?
> Any suggestions to safe guard against this?
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|