Most of the antique parts suppliers have the screwdrivers (set of 4) but
they strip out almost immediately for me, so I am trying to locate all 4 in
bits in the hopes they are made of stronger steel. So far we have located
the smallest 3 bits, but the 5/16 is eluding us. Anyone know of a source?
Also, in working on these vent windows, I have a need for a riveting tool.
Not a pop rivet tool that is common in most hardware stores, but one that
presses in the kind of rivets that are used on our trucks in many places. I
bought a punch from Chevy Duty and altho its good quality, doesnt allow you
to get into tight places. Some kind of rivet pressing tool (hand held) would
be better if there is such a thing. Does anyone know of such a thing and a
good rivet supply source?
Deve Krehbiel
Hesston, Kansas
1950 3100 * 1949 3600 * 1948 4400 * 50 3100
www.speedprint.com/Deves50/index.html
----- Original Message -----
From: "Richard Reul" <rreul@cin.net>
To: "tcape" <tcape@weblnk.net>; "Michael Mendonca" <mm@service-quality.com>;
"Old Trucks" <oletrucks@autox.team.net>
Sent: Wednesday, January 17, 2001 6:31 AM
Subject: Re: [oletrucks] Clutch Head Bits
> Found mine at the local Ace hardware. If I remember right I paid around
$15
> for a set of three.
> R. Reul
> 1951 3604
> rreul@cin.net
> ----- Original Message -----
> From: "tcape" <tcape@weblnk.net>
> To: "Michael Mendonca" <mm@service-quality.com>; "Old Trucks"
> <oletrucks@autox.team.net>
> Sent: Tuesday, January 16, 2001 8:49 PM
> Subject: Re: [oletrucks] Clutch Head Bits
>
>
> > Snap-On makes the clutch head screwdrivers. Several members have also
> said
> > they found them at their LAPD (local auto parts dealer).
> > Tom Caperton
> > 47-2nd 3100....in Whiteville, NC
> > tcape@weblnk.net
> >
> >
> > ----- Original Message -----
> > From: "Michael Mendonca" <mm@service-quality.com>
> > To: "Old Trucks" <oletrucks@autox.team.net>
> > Sent: Tuesday, January 16, 2001 3:54 PM
> > Subject: [oletrucks] Clutch Head Bits
> >
> >
> > > A few weeks back some of you indicated that you have been unable to
> locate
> > clutch hed bits/drivers. I ordered a set from tool-plus.com and they
are
> > fine. Only problem is they only go to 1/4 inch and not to 5/16. There
> are
> > other sources for the other.
> > >
> > > Michael '54 Chevy 3100
> > > oletrucks is devoted to Chevy and GM trucks built between 1941 and
1959
> > oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
> oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|