>I've recently added a mig conversion kit to my 115 volt Lincoln wire
>welder. I must have been shorted an instruction sheet somewhere, as I
>can't find any listing of gas regulator settings. I am using .025 solid
>wire, with a gas mix of 75%argon : 25%CO2, attempting to repair stress
>cracks in AD bed sides. Can someone give me a base setting of where to
>start with the regulator setting?
Michael, the regulator setting isn't that critical because the gas should
only flow when you have the trigger pulled. Open up the valve a goodly way
and then the gun will do the rest for you.
Regards,
Grant S
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|