Dear Gang:
I purchased a turnsignal kit from Jim Carter's. The directions are
absolutely lousy. Words are missing, all in upper case letters, hard to
read, pointing to #'s on wires that aren't numbered, etc.
The previous owner had put on new rear lights. I have dbl filament bulbs
in rear and also in front now. I have the afore mentioned toggle switch kit.
Do any of you have any ideas on how to wire this. My brake lights work. Do
I just tie in to my brake light lines and run to the switch or will that
cause my lights to flash when I put on the brakes. If any of you have used
this kit or have another idea. I sure could use your help.
Jon Callahan
'50 3100
Champaign/Urbana, IL
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|